Re: [fluka-discuss]: Problems about source and input file

From: Mikhail Polkovnikov <pmk_at_ihep.ru>
Date: Wed, 2 May 2018 09:47:55 +0300

On 29.04.2018 19:42, 魏朔阳 wrote:
> Dear FLUKA experts and users,
>
> I have been simulating electrons incident on a copper target and using
> USRBIN card to obtain the energy deposited in a diamond detector. I
> wrote the source file and compiled it, then I tried to run the fluka
> input file, but it was done just a few seconds later, didn't give me
> the scored result such as xxxx_fort.66. By the way, there is no .err
> file, could anyone help me to point out what's wrong with my source or
> input file? Thanks! Attachments are the relevant files.
>
> Best regards!
>
> Wei
>
> --
> *
> *
> *Shuoyang Wei *
> Department of Engineering Physics, Tsinghua University
> Tel: (+86)13121985856
> Mail: weisythu_at_qq.com
>          weisy14_at_mails.tsinghua.edu.cn
>
> 编辑删除


Dear Wei,

There is a error in DEC1 body definition, and another error you might
have seen in the ENERGYdeposinDiamond001.out  file.

   **** Low energy neutron xsec not found for some media  2 3 ****
  DIAMOND


You can either use LOW-MAT card to define a required cross sections, or
disable low-energy neutron group transport.

*...+....1....+....2....+....3....+....4....+....5....+....6....+....7....+....
LOW-MAT      DIAMOND        6.       -3. 296.                    CARBON


Best regards,

Mikhail



__________________________________________________________________________
You can manage unsubscription from this mailing list at https://www.fluka.org/fluka.php?id=acc_info
Received on Wed May 02 2018 - 10:27:05 CEST

This archive was generated by hypermail 2.3.0 : Wed May 02 2018 - 10:41:37 CEST