Dear Emerson,
Currently it is not possible to use the SPOTBEAM cards in the fluka2011.2x.6.
For your purpose, I would recommend using source routine.
Kind Regards,
Wioletta Kozłowska
CERN & Medical University of Vienna
CERN EN-STI-FLU
Office: 864-02-D01
Phone +41 22 76 75461
CH-1211 Geneve 23, Switzerland
________________________________
From: owner-fluka-discuss_at_mi.infn.it [owner-fluka-discuss_at_mi.infn.it] on behalf of Emerson Mario Boldo [Emerson.Boldo_at_unioeste.br]
Sent: 23 April 2019 18:33
To: fluka-discuss_at_fluka.org
Subject: [fluka-discuss]: About BEAMSPOT, SPOTBEAM, SPOTPOS and SPOTDIR
Dear Fluka users,
I'm using the latest version of Fluka / Flair (fluka2011.2x.6) via Docker on Win10.
In the 2018 version of Fluka Manual, it says that we can set multiply beams using SDUM = BEAMSPOT
on the SPECSOUR card and then properly configuring SPOTBEAM, SPOTPOS and SPOTDIR.
However I got the following error:
*** Unknown control code: SPOTBEAM, ignored ***
***** Next control card ***** SPOTBEAM
**** Unknown Input card !!!!!!!!! ****
Is this function not yet implemented in Fluka?
I need to simulate two pencil beams of photons (90 degrees to each other)
converging to the same point, I think using SPOTBEAM, SPOTPOS and SPOTDIR
was the easiest way to do this, right?
Thanks in advance,
Emerson
__________________________________________________________________________
You can manage unsubscription from this mailing list at
https://www.fluka.org/fluka.php?id=acc_info
Received on Wed Apr 24 2019 - 11:27:13 CEST