I'm a new Fluka user. I can only build/compile the 32-bit Fluka as I don't have gfortran7.4 nor 8.3.
I have built 32-bit Fluka executables (flukahp) in two machines of 64-bit, one is running Scientific Linux (=Red-Hat) 6 and the other one is Scientific Linux 7.
But in both machines (which are built a bit differently), when I ran on "example.inp", it would stop or get stuck somewhere at cycle 4, after (eg. in one machine)
56000 events. I wonder why this happened ?! It'd finish 3 cycles nicely.
I've tried to put in TIME-CUT what(4) and what(5) (in case there is an infinite loop) but it doesn't help. Setting What(6) doesn't help either.
If I change the RANDOMIZ in example.inp, it'd change where it'd stop (eg. it may stop earlier !) but it can never get past cycle 4.
I've also tried to change -O3 to -O0 or get rid of "-mcpu=... -fexpensive-optimizations" in the compilation. But all these don't help either (it'd still get stuck at
cycle 4 when I run the original example.inp).
I hope the experts can tell us what's wrong :-(
Kin
On 4/30/19 8:52 AM, Nacira HANOUF wrote:
Dear Fluka Experts,
when i typing '$FLUPRO/flutil/rfluka -N0 -M5 example.inp'
fluka is stopped at 'Running FLUKA for cycle #1'
I tried the same thing with simple examples I worked on before but the results were the same.
I using Toshiba Laptop.
cpu : i5-4300M 2601 MHz, RAM 8 GB.
__________________________________________________________________________
You can manage unsubscription from this mailing list at https://www.fluka.org/fluka.php?id=acc_info Received on Tue Apr 30 2019 - 19:35:16 CEST
This archive was generated by hypermail 2.3.0
: Tue Apr 30 2019 - 19:55:48 CEST