Thank you for your suggestion.
Now the problem is that i am getting the usrbin errors only as 99% and 0%
ir-respective of the number of particles that i run.i have run the same file
previously when i was getting only few percent of errors.Although i tried it
for the same number of particles as well as i had done previously when i was
getting only 6-10% error, but now i am getting only 99% and 0%.since the
values of yield/stars are different and the particle fluences are also
different in different regions(as seen from usrbin) i think there is some
error done by the code in calculating the errors.
I will be looking forward for your suggestions
Thank you
On Mon, Jun 20, 2011 at 8:49 PM, turgay hhhhhhhhh
<turgaykorkut_at_hotmail.com>wrote:
>
> Dear MIR INAMUL HAQ JERI,
>
> in FLAIR you should suitable set Attach Timeout limit.
> Tools<Preferences<Interface<Attach timeout
>
> I fixed this problem using 100000 s. for attach timeout limit.
>
> I hope it helps.
>
> Regards.
>
> Turgay Korkut
>
>
-- MIR INAMUL HAQ JERI INSTN SACLAY. UNIVERSITY OF PARIS SUD 11.Received on Tue Jun 21 2011 - 23:59:01 CEST
This archive was generated by hypermail 2.2.0 : Tue Jun 21 2011 - 23:59:10 CEST