.... bus errors are usually problems connected with the operating
system/hardware of the computer you are running on and normally they have
nothing to do with Fluka. On our cluster we get similar errors (very rare)
if the node the batch job is running on temporarily loses the nfs
connection to the master node, but I do not know if this applies to your
case as well
Alfredo
+----------------------------------------------------------------------+
| Alfredo Ferrari || Tel.: +41.22.76.76119 |
| CERN-EN/STI || Fax.: +41.22.76.69474 |
| 1211 Geneva 23 || e-mail: Alfredo.Ferrari_at_cern.ch |
| Switzerland || |
+----------------------------------------------------------------------+
On Thu, 4 Apr 2013, Sudeshna Banerjee wrote:
> Hello,
>
> I am trying to run fluka with a geometry file for the CMS detector. But
> my batch jobs are failing after several hours. A core file is created but
> the *.err, *.out and *.log files do not show any error messages. The only
> error I see is in the batch job submission log file. It says -
>
> ======================= Running FLUKA for cycle # 1 =======================
> /afs/cern.ch/user/b/bhat/scratch1/sudeshna/fluka/flutil/rfluka: line 358:
> 5268 Bus error
> (core dumped) "${EXE}" < "$INPN" 2> "$LOGF" > "$LOGF"
>
> ____________________________________________________________________________
> How do I find out what went wrong ?
> Also, is there a way to control the number of collisions that are generated
> ? I am guessing that if I can run the job for 1 or 2 collisions, then I will
> not have to wait too long to find out if the job is going to fail.
>
> Thanks
> Sudeshna Banerjee
>
>
>
>
>
Received on Thu Apr 04 2013 - 20:47:58 CEST
This archive was generated by hypermail 2.3.0
: Thu Apr 04 2013 - 20:47:59 CEST