[fluka-discuss]: The inconsistency between EMFCUT setting and XX001.out file
Dear everyone,
When I see my XX001.out file,I found the inconsistency between EMFCUT setting and XX001.out file.
In my EMFCUT,I set transport cutoff "EMFCUT -0.00001 0.000001 left VOID".Clearly,I set electron transport cutoff is 10KeV.
However,in the XX001.out file,it shows
"1 Correspondence of regions and EMF-FLUKA material numbers and names:
Region EMF FLUKA
1 0 VACUUM 1 BLCKHOLE
2 0 VACUUM 2 VACUUM
3 1 CARBON 6 CARBON
Ecut = 6.1100E-01 MeV, Pcut = 3.3333E-02 MeV, BIAS = F, Ray. = T, S(q,Z) = T, Pz(q,Z) = T"
From this,we can see the electron transport cutoff is 0.1MeV. Meanwhile,It seems the code runs according to this(the electron transport cutoff is 0.1MeV).This is the problem. Why does this inconsistency happen?
Thanks for any suggestion.
Best Regards
Chen Yuan
Received on Sat Jan 11 2014 - 15:38:40 CET
This archive was generated by hypermail 2.3.0
: Sat Jan 11 2014 - 17:06:03 CET