Dear Thiago!!
Thanks for your reply.
I was just trying to implement it first time after going through manual.
That's why wanted to be sure about its proper implementation.
A check by someone who has done similar application will be useful.
Thanks,
Deepak Akar
BARC, Mumbai
> Dear Deepak,
>
> Have a look at the slides from the Fluka courses as this information is
> available there. Furthermore, for a quick verification you can set some
> scoring regions just after your beam position and evaluate its behaviour
> easily with flair geometry tool.
>
> Best wishes
>
> Thiago
>
>> On 24 Sep 2015, at 07:49, akardeep_at_barc.gov.in wrote:
>>
>> Hello!!
>>
>> I want to project a Beam along Y axis. For this I am planning to use
>> BEAMAXES card. In this card I am thinking of following entries:
>> cosBxx=0.0 cosBxy=0.0 cosBxz=1.0
>> cosBzx=0.0 cosBzy=1.0 cosBzz=0.0
>>
>> I further want to make the beam width 180 cm in z direction and 50 cm in
>> x
>> direction with beam center as z=90 and x=25 (,Y=-10 as starting point).
>> For this I set shape as rectangular and delta(phi) as flat in BEAM card
>> along with delta(x)=180 and delta(y)=50.
>> In BEAMPOS I set z=0, x= and y=-10.
>>
>> In further geometry I assume the normal way of defining co-ordinates.
>> Is it the right approach or some modifications are required?
>>
>> What are the cards (and entries) appropriate to verify the beam
>> direction
>> and its width?
>>
>> Thanks and Regards
>> Deepak Akar
>> BARC, Mumbai
>>
>> __________________________________________________________________________
>> You can manage unsubscription from this mailing list at
>> https://www.fluka.org/fluka.php?id=acc_info
>>
>
>
>
__________________________________________________________________________
You can manage unsubscription from this mailing list at
https://www.fluka.org/fluka.php?id=acc_info
Received on Mon Sep 28 2015 - 11:17:40 CEST