stops the execution of the program
(see also START)
WHAT(1)..WHAT(6) and SDUM : not used
Default (option STOP not given): no effect (the program stops at the
end of the run when the conditions set in the START command are
satisfied).
Inserted at any point in a FLUKA input sequence before the START
command, a card STOP interrupts input reading and de-activates all
the following cards. It can thus help in debugging input. After
START, its presence is optional and has no effect.
When running the geometry debugger or plotting a slice of the
geometry, it is often convenient to place a STOP command just after
the GEOEND cards or after the PLOTGEOM input.
Otherwise, once the debugging or plotting has been completed,
FLUKA would continue reading input cards and eventually would start
particle transport as soon as a card START is found.
Example:
*...+....1....+....2....+....3....+....4....+....5....+....6....+....7....+...
GEOEND 150. 75. 220. 30. 0. -220.DEBUG
GEOEND 120. 1. 110. 0. 0. 0. &
STOP
* Debugs the geometry and stops without starting a simulation
