RE: [fluka-discuss]: no random file available- error during run

From: Eleftherios Skordis <>
Date: Tue, 22 May 2018 16:39:51 +0000

Dear Evagelia,

the problem can be found in the .out file of the first cycle.
You have not defined a LOW-MAT cross-section for your material (amer). If you assigned a LOW-MAT card your input should be working fine.

You were probably looking at a cycle after that and that is why you see this error (since the previous cycle did not finish there was no random file generated for the other cycles to start)

hope this helps

kind regards



Eleftherios Skordis
CH-1211 GENEVA 23

OFFICE: +41-22-7679541

From: [] on behalf of Ευαγγελία Κιοσέογλου []
Sent: 20 May 2018 18:10
Subject: [fluka-discuss]: no random file available- error during run

I was trying to run the attached project but got the following in my
out. file: **** No Random file available !!!!!! ****
  Abort called from FLRM64 reason NO RANDOM FILE Run stopped!

Is it a problem with my input file or am I missing a step?

Thank you

You can manage unsubscription from this mailing list at¬c_info
Received on Tue May 22 2018 - 19:47:05 CEST

This archive was generated by hypermail 2.3.0 : Tue May 22 2018 - 19:47:07 CEST