.... again
you are obviously reading the cosines without the full 16 digits required
+----------------------------------------------------------------------+
| Alfredo Ferrari || Tel.: +41.22.76.76119 |
| CERN-EN/STI || Fax.: +41.22.76.69474 |
| 1211 Geneva 23 || e-mail: Alfredo.Ferrari_at_cern.ch |
| Switzerland || |
+----------------------------------------------------------------------+
On Sun, 14 Jul 2013, Joe Mildenberger wrote:
> When I run the second step of a two-step model and read in starting
> values from a source file, I get huge .err files.
>
> I hasten to add that there are apparently no real errors that I can find
> listed in the files, just thousands and thousands of entries of the form
>
> Jtrack, Etrack 8 0.939590109600000
> GEOFAR, TXYZ: 0.999999999694202
> 0.794822116000000 -0.180331337000000 -0.579429385000000
> Nfrom, Nreg, X, Y, Z 1001 51
> -864.880746000000 47.6401516000000 3048.00000000000
> Jtrack, Etrack 8 0.939565630105940
> GEOFAR, TXYZ: 0.999999999775368
> -0.119170720000000 -5.087247140000000E-03-0.992860745000000
> Nfrom, Nreg, X, Y, Z 1001 51
> -880.159423000000 66.2758347000000 3048.00000000000
> Jtrack, Etrack 8 0.939963188000000
> GEOFAR, TXYZ: 1.00000000021697
> 0.654909806000000 -0.106889125000000 -0.748109525000000
> Nfrom, Nreg, X, Y, Z 1001 51
> -900.314958000000 33.6777587000000 3048.00000000000
> Jtrack, Etrack 8 0.939963188000000
>
> These diagnostic statements are not coming from my source.f file, and I
> would like to know how to turn them off, because the amount of output is
> enormous, about 0.5 GB for a run of 2e6 primaries.
>
> Thanks for any help anyone can offer!
>
> Joe
>
>
Received on Tue Jul 16 2013 - 00:05:55 CEST
This archive was generated by hypermail 2.3.0
: Tue Jul 16 2013 - 00:05:59 CEST