From: Stefan Roesler (sroesler@mail.cern.ch)
Date: Wed Feb 13 2008 - 22:43:55 CET
Hello
RCC 3 and RPP 4 do not overlap; thus regions 3 and 4 don't make sense.
RCC 3 has the center of one of its circular faces at (x,y,z)=(0,0,3), is
aligned with z and has a length of 200cm. However, RPP 4 only extends from
0 to 1.96cm in z.
Just a few other comments:
- BERYLLIUM and IRON are both predefined materials in FLUKA. Thus the
MATERIAL cards are not needed
- The SDUM of your EMFCUT card is misaligned.
- What(4) and What(5) of EMFCUT/PROD-CUT refer to a range of FLUKA
material indices, with What(4) being the lower limit and What(5) the
upper. In your case What(5)<What(4), I guess What(5) is forced to be
equal to What(4).
Regards
Stefan
On Wed, 13 Feb 2008, Buthaina Abdalla Suleiman Adam wrote:
> Hi
> I'm a beginner of fluka, I want to get the flux of neutron out side iron
> tube (cylinder 200cm long) placed 2cm away from the source (P irradiated
> Be target). My problem that I couldn't introduce these iron tube correctly
> (always give me wrong geometry) I attach my input file.
>
> Thank You in Advance,
> Buthaina Adam
>
-- ___________________________________ Stefan Roesler CERN, SC/RP CH-1211 Geneva 23 Switzerland Phone: +41-22-7679891 Fax: +41-22-7669639 E-mail: Stefan.Roesler@cern.ch
This archive was generated by hypermail 2.1.6 : Thu Feb 14 2008 - 09:15:25 CET