Dear Mina,
If you want to try different shielding configuration I would do as suggested
by Thomas in your earlier post and identify the relevant isotopes analytically
using the gamma-constant. Then for each relevant isotopes (or each type of
emitters for the sake of simplicity ?) I would do a calculation with a
cylindrical or Cartesian source depending on the shape of your gas container,
and use the HI-PROPE card to specify which isotope decay to consider (primary
will be sampled from the isotope decay...). Then you can know for example that
for each Bq of decay of a given isotope homogeneously distributed inside your
gas container you associate a given dose rate on contact of your shielding...
Hope this help
Joachim
-----Original Message-----
From: owner-fluka-discuss_at_mi.infn.it [mailto:owner-fluka-discuss_at_mi.infn.it=
] On Behalf Of Mina Nozar
Sent: 08 September 2011 19:30
To: fluka-discuss_at_fluka.org
Subject: Using res. nuc. inventory for different shielding config.
Hello everyone,
Is it possible to use a residual nuclei inventory (at a given coolin
time) as a source (isotropic) to assess different
rad. decay shielding configurations?
Thank you and best wishes,
Mina
Received on Fri Sep 09 2011 - 18:36:22 CEST
This archive was generated by hypermail 2.2.0 : Fri Sep 09 2011 - 18:36:23 CEST