Hello Vahan,
USRTRACK + DOSE-EQ: Dose equivalent in a given region
USRBDX + DOSE-EQ: Dose equivalent crossing the boundary between two regions
Units in both cases (for prompt radiation):
pSv/GeV/prim - from the tab.lis file, plotting DOSE-EQ as y vs Eenergy as x.
pSv/prim - from the tab.lis file, plotting DOSE-EQ*Energy as y*dx vs Energy as x.
For residual radiation, units are pSv/GeV/s and pSv/s
But as Alberto has mentioned:
"I call your attention to the fact that, while it is always useful to look
for an energy spectrum of fluence, it is usually less useful to look for
a "spectrum of dose equivalent". What you want is its integral between two
energies (the units for your integral dose equivalent will be pSv/prim,
and you get rid of "GeV")."
You will get this from the sum.lis file which is: sum[(E(i+1)-E(i))*DE(i)] over all energy bins defined in your
estimator card.
Hope this helps,
Mina
On 12-06-18 05:16 AM, Vahan Petrosyan wrote:
> Hi I calculated Equivalent Dose by using usrbin card with part type setto DOSE-EQ. I was able to plot DOSE vs. Distant
> of source by using 1D plot of Usrbin card.
>
> I just want to understand what I get If USERTRACK and USRBDX card switched on with part type DOSE-EQ.?
> In result plot what is on Y vertical and on X horizontal axes?
>
> I attached my input file.
> Thanks!
Received on Tue Jun 19 2012 - 23:37:29 CEST
This archive was generated by hypermail 2.2.0 : Tue Jun 19 2012 - 23:38:00 CEST