Parameter in routine atmloc_2011.f
Dear fluka experts,
When i run atmloc_2011 to create the geometry file for earth, the following
parameter is asked :
"Geomagnetic cut-off acceptance (GeV)"
I am not sure to understand what is it? Is it the rigidity cut-off at the
latitude and longitude of interest? Is it the vertical rigidity cut-off
that can also be specified in SPECSOUR card? Is it anything else?
Thank you in advance for help
Pierre-Simon Mangeard
*********************************************************
Space Physics and Energetic Particles Research
Department Of Physics
Faculty of Sciences
Mahidol University
Bangkok, Thailand
*********************************************************
Received on Sat Aug 31 2013 - 12:35:00 CEST
This archive was generated by hypermail 2.3.0
: Sat Aug 31 2013 - 12:35:01 CEST