[fluka-discuss]: Abort called from FLLACT
Dear FLUKA authors
While trying some activation calculations, I ended up with this crash.
Abort called from FLLACT reason ANIRR TOO SMALL Run stopped!
STOP ANIRR TOO SMALL
What could be the reason for this crash?
A different input file runs well without this crash. I get this crash after
I replaced a few stainless steel components with an Al alloy.
I am using fluka2011.2b-6.
Thanks for all the help
Best Regards
Sunil
Received on Wed Apr 09 2014 - 17:24:11 CEST
This archive was generated by hypermail 2.3.0
: Wed Apr 09 2014 - 17:24:11 CEST