Re: [fluka-discuss]: Co60 gamma field
Hello Uwe,
You have some interesting topics related to your issue on the mailing
list archives.
- To generate a Co-60 isotropic source, you have to set WHAT(3)> 2 pi
rad, SDUM from BEAM card to ISOTOPE and then describe A and Z from Co-60
in a HI-PROPE card (look at the manual, BEAM section)
- To activate radioactive decay in semi-analogue mode you have to set a
RADDECAY card (look at the manual, RADDECAY section)
- The adequate detector to your problem seems indeed to be a USRBIN card
Hope it helps somehow.
Regards.
Sébastien.
2014-09-22 20:03, Uwe Riesterer (uwe.riesterer_at_hs-furtwangen.de) wrote:
> Dear FLUKA-Team.
>
> I´m an absolutely rookie in FLUKA. For which reason I mainly use the
> graphical interface Flair on FLUPIX. But for my work I have to
> simulate a gamma field (85*120cm) generated by a little cobalt 60
> source (radiant in all directions), with different absorber materials
> in it. The result should be a 2D view of the gamma radiation through
> the various absorbers (Pb, Fe, Al and PMMA) with the corresponding
> weakening.
>
> The geometry etc. is not the problem, but I have problems with:
>
> *
>
> the correct configuration of the Co60 BEAM
> *
>
> what setting is the right one for my problem and how I have to
> configure it
> (is it USRBIN, RADDECAY ...)
>
> I work a lot with the Flair- & FLUKA-Manual, but without the necessary
> experience in this area it´s not easy.
> I´m learning by trying and doing.
>
> So please, could you help me further?
> Or do you have any suggestions?
>
> ***************************************************
> Riesterer Uwe
>
> Furtwangen University of Applied Sciences
> Security & Safety Engineering
> ***************************************************
Received on Mon Sep 22 2014 - 22:31:37 CEST
This archive was generated by hypermail 2.3.0
: Mon Sep 22 2014 - 22:31:38 CEST