Dear Mattias,
Our guess is that usxsuw (or the like) ended up calling fluka's main,
which it shouldn't do. If this is the case, the solution by Nunzio Tino
Burgio is available from:
http://www.fluka.org/web_archive/earchive/new-fluka-discuss/5339.html
Cheers,
mary
On Mon, 15 Apr 2013, Lantzelot wrote:
> Dear FLUKA authors,
>
> I have installed the pre-compiled gfortran-4.5.1 version of FLUKA.
> Execution seems to work fine, but when using the routines for handling
> scoring output there is an error that I do not understand.
>
> I try to use for instance usxsuw both from the command prompt and
> through flair, the result is two files, fort.11 and fort.15 with the
> following error messages.
> For the example below the example.inp file has been used.
>
>
> > more fort.15
> *** Unknown control code: example0, ignored ***
>
>
> > more fort.11
> [I have cut out most of the .out information that shows up here]
> ...
> ...
> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
> !!!! DOWNLOAD/USE OF THE FLUKA SOFTWARE IMPLIES FULL !!!!
> !!!! ACCEPTANCE AND COMPLIANCE WITH THE LICENSE !!!!
> !!!! CONDITIONS !!!!
> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
>
> Note: The Nuclear Energy Agency Data Bank is an authorized
> distributor of the code
>
> 1
> ****************************************************************************************************
>
> FLUKA2011 Version 2.17 Dec-12 by A. Ferrari DATE: 4/15/13 TIME: 1:52:22
>
> ****************************************************************************************************
>
>
> *---------------- ----------------*
> *---------------- ----------------*
> *---------------- ----------------*
> *---------------- ----------------*
> *---------------- ----------------*
> *---------------- ----------------*
> *---------------- ----------------*
>
> *** Unknown control code: example0, ignored ***
>
>
> ***** Next control card ***** example0 0.000 0.000 0.000 0.000 0.000 0.000
>
> **** Unknown Input card !!!!!!!!! ****
>
>
> If I change the output to ascii format the data is there, so FLUKA seems
> to run properly.
> Any ideas where to look for errors?
>
> Best wishes,
> Mattias Lantz
>
> --
> Mattias Lantz - Researcher
> ã?©ã?³ã?? ã??ã??ã?£ã?¢ã?¹
> Department of Physics and Astronomy
> Division of Applied Nuclear Physics
> Uppsala University, Box 516
> SE - 751 20, Uppsala, Sweden
> phone: +46-(0)18-471-3754
> cell: +46-(0)730-454-384
> fax: +46-(0)18-471-5999
> email: mattias.lantz_at_physics.uu.se
>
>
>
>
Received on Tue Apr 16 2013 - 09:34:39 CEST