RE: Read USRBDX binary output

From: Mario Santana Leitner (Mario.Santana@cern.ch)
Date: Tue May 30 2006 - 09:20:02 CEST

  • Next message: Alberto Fasso': "Re: Question about STEPSIZE"

    Hi,

    You should use usxfuf
    Normally the ...fuf programs serve to pass from ascii to binary and viceversa (another example would be usbfuf)

    cheers

    Mario

    -----Original Message-----
    From: owner-fluka-discuss@fisica.unimi.it on behalf of Sunil C.
    Sent: Tue 5/30/2006 7:30 AM
    To: fluka-discuss@mi.infn.it
    Subject: Read USRBDX binary output
     
    Hi All

    I was trying to follow the example in the manual to get the USRBDX outputs
    from independent runs. The manual says use of usxsuw.f gives 3 outputs,
    from the example in the beginners's guide, the files pion,
    pion_sum.lis,pion_tab.lis. The manual further says to use usxsuw to
    operate on the the file pion(which is a binary file) to get the ascii
    file. I tried this and the output i get is another binary file. Is there
    another program to do this?
    I remeber a comment to that effect in some mail in this forum.

    regards

    SunilC
    Heath Physicist
    Pelletron, TIFR


  • Next message: Alberto Fasso': "Re: Question about STEPSIZE"

    This archive was generated by hypermail 2.1.6 : Tue May 30 2006 - 10:19:51 CEST