Hello both
one can also access the information in comscw.f,
adding
INCLUDE '(TRACKR)'
the particle energy (total) is in the ETRACK variable
Paola
On 06/09/2017 05:37 PM, Віктор Родін wrote:
> Dear Christopher
> I can give advice to use for this purpose mgdraw subroutine,
> especially ENDRAW entry. It gives you information about a point where
> energy was deposited and you can also receive energy of the particle.
> You can find more information there
> https://indico.cern.ch/event/489973/contributions/2000440/attachments/1272042/1972478/09_AdvancedUserRoutines2016.pdf
> Best regards,
> Viktor
>
> 2017-06-09 17:31 GMT+03:00 Willis, Christopher <willis.276_at_osu.edu
> <mailto:willis.276_at_osu.edu>>:
>
> Hello,
>
> I am relatively new to fluka, and had a question about including a
> detector response function in my binning detectors (USRBIN) using
> comscw. I am simulating a stack of detectors that will be used to
> measure the spatial distribution of a beam of protons at various
> energies, and want to include a dose normalization based on the
> proton energy at the detector. (Essentially, the detector has an
> under-response for protons whose bragg peak lies within the active
> layer of the detector.)
>
> I've figured out how to get at particle INITIAL energies in
> comscw, but can't figure out how to get the energy at the point of
> energy deposition being binned.
>
> If anyone could offer a suggestion as to how to access this
> instantaneous particle energy, that would be greatly appreciated.
>
> Thanks,
>
> Christopher Willis
>
> Post-Doctoral Researcher
>
> The Ohio State University
>
>
__________________________________________________________________________
You can manage unsubscription from this mailing list at
https://www.fluka.org/fluka.php?id=acc_info
Received on Sat Jun 10 2017 - 13:45:06 CEST