Odp.: Odp.: [fluka-discuss]: problems with materials (too short time of simulation)

From: Knyziak Adrian <a.knyziak_at_gum.gov.pl>
Date: Thu, 2 Nov 2017 13:09:41 +0000

Hello George,

Thank you very much for your help and explain problem.

Best regards,

Od: George Kharashvili <georgek_at_jlab.org>
Wysłane: 2 listopada 2017 14:05
Do: Knyziak Adrian
DW: FLUKA Discussion List
Temat: Re: Odp.: [fluka-discuss]: problems with materials (too short time of simulation)

Hello Adrian,

If you run your input without the LOW-MAT card, the run will end with the following error (written at the end of the .out file):
**** Low energy neutron xsec not found for some media 4 5 ****

Although there should be no neutrons in your problem, you are using PRESISIOn default, which, as the manual explains, automatically activates neutron transport: "Low energy neutron transport on down to thermal energies included". So, when the run is initiated, every material has to be linked to its corresponding low-energy neutron cross-section. GRAPHITE is not one of the FLUKA pre-defined materials and the code does not know which low-energy neutron cross-section to apply to it. Hence you must have the LOW-MAT card, as explained in the note 3 of the LOW-MAT manual page.


You can manage unsubscription from this mailing list at https://www.fluka.org/fluka.php?id¬c_info
Received on Thu Nov 02 2017 - 15:27:48 CET

This archive was generated by hypermail 2.3.0 : Thu Nov 02 2017 - 15:27:50 CET