Dear Raushan,
indeed this is a known problem to the devs that in some rare cases the code runs into this problem.
It should be addressed in a later release.
For now, since this is a "rare" case what you can do is to have multiple cycles/runs with a lower number of particles. It might be that some of the runs crush but the results of the rest of the simulations should be valid.
Hope this helps
Kind regards
Lefteris
-----------------------
Eleftherios Skordis
Dep. EN/STI, CERN
CH-1211 GENEVA 23
SWITZERLAND
OFFICE: +41-22-7679541
________________________________________
From: owner-fluka-discuss_at_mi.infn.it [owner-fluka-discuss_at_mi.infn.it] on behalf of kabytayeva [kabytayeva_at_jinr.ru]
Sent: 24 November 2018 13:31
To: Fluka Discuss
Subject: [fluka-discuss]: An interrupt triggered from the cause BME / READR0 A out of range for proj / target
Dear FLUKA experts!
FLUKA had not show errors at input file, but when I run 100,000
particles everything is fine, but if I increase the value, say, to
1000000, then the following error:
An interrupt triggered from the cause BME / READR0 A out of range for
proj / target Run stopped!
STOP A out of range for proj / target
Do you know how to solve this problem?
Many thanks
Best regards,Raushan
__________________________________________________________________________
You can manage unsubscription from this mailing list at
https://www.fluka.org/fluka.php?id¬c_info
Received on Sun Nov 25 2018 - 18:38:09 CET