Dear Experts,
I have tried to use EMF cut with my input for learning purpose. (Please find attached the .inp and .out files )
In both the .out files, with and without EMF cut card, I could see the statements:
Cut-off kinetic energy for ELECTRON transport defined in the Emfcut card
Cut-off kinetic energy for POSITRON transport defined in the Emfcut card
Cut-off kinetic energy for NEUTRIE transport: 0.000E+00 GeV
Cut-off kinetic energy for ANEUTRIE transport: 0.000E+00 GeV
Cut-off kinetic energy for PHOTON transport defined in the Emfcut card
My doubt is when there is no EMFCUT card in the input, why should this be printed? Kindly clarify. Where to locate the set values of EMF cut card in the .out file ?
Another doubt: how to understand the following? What does Ae, Ap, Ue and Up stand for ? Ecut = K.E cut and Pcut = Production cut, right ?
AIR
Rho = 1.204790E-03 g/cm**3 Rlc= 30392.0 cm
Ae = 0.610999 MeV Ue = 5062.39 MeV
Ap = 3.333333E-02 MeV Up = 5061.88 MeV
dE/dx fluctuations activated for this medium, level 1
below the threshold for explicit secondary electron production
(up to 2I discrete levels, up to 2 K-edges)
1 Correspondence of regions and EMF-FLUKA material numbers and names:
Region EMF FLUKA
1 BLKBODY 0 VACUUM 1 BLCKHOLE
2 VOID 1 AIR 26 AIR
Prompt:
Ecut = 6.1100E-01 MeV, Pcut = 3.3333E-02 MeV
BIAS = F, Ray. = T, S(q,Z) = T, Pz(q,Z) = T, Acolin.= F
Delayed:
Ecut = 6.1100E-01 MeV, Pcut = 3.3333E-02 MeV
3 Detector 1 AIR 26 AIR
Prompt:
Ecut = 6.1100E-01 MeV, Pcut = 3.3333E-02 MeV
BIAS = F, Ray. = T, S(q,Z) = T, Pz(q,Z) = T, Acolin.= F
Delayed:
Ecut = 6.1100E-01 MeV, Pcut = 3.3333E-02 MeV
Thanks so much.
Regards,
Raksha R.
__________________________________________________________________________
You can manage unsubscription from this mailing list at
https://www.fluka.org/fluka.php?id=acc_info
Received on Wed May 06 2020 - 14:53:54 CEST