RE: replica of complicated body

In the attachment you can find the corrected input file.

Best regards,
Vitaliy



> -----Original Message-----
> From: Paola Sala [mailto:paola.sala_at_mi.infn.it]
> Sent: 16 ноября 2010 г. 17:06
> To: Gostishchev, Vitaliy Dr.
> Cc: Paola Sala; fluka-discuss_at_fluka.org
> Subject: RE: replica of complicated body
>
>
> Hi
> could you please send the corrected input?
>
> > Hello,
> >
> > Thank you for your reply. I corrected that error but,
> unfortunately, I
> > still cannot see a replica in the corresponding position.
> I see only
> > RPP consisting of the blackhole material. It's fine but I
> expect that
> > the replica inside RPP can be seen, if I plot a geometry with a
> > standard geometry plotter in FLAIR. But it's not a case.
> What can be a
> > reason for that? Maybe geometry of the replica is too complicated?
> >
> > Thank you for any suggestions.
> >
> > Best regards,
> > Vitaliy
> >
> >
> >
> >
> >> -----Original Message-----
> >> From: owner-fluka-discuss_at_mi.infn.it
> >> [mailto:owner-fluka-discuss_at_mi.infn.it] On Behalf Of Paola Sala
> >> Sent: 15 ÎÏÑÂÒÑ 2010 Ç. 9:55
> >> To: Gostishchev, Vitaliy Dr.
> >> Cc: fluka-discuss_at_fluka.org
> >> Subject: Re: replica of complicated body
> >>
> >>
> >> Hello,
> >> I find an error in the geometry: region Ped uses a body
> "ped" that is
> >> not defined Regards Paola
> >>
> >> > Dear FLUKA experts,
> >> >
> >> > I have a question concerning replicas in FLUKA. I cannot
> >> succeed with
> >> > replication of the complicated quadrupole. Maybe the whole
> >> input file
> >> > is too complicated or there is another reason. Nevertheless, I
> >> > created a quadrupole in the parking region and want to
> place its
> >> > replica in the position of z-axis from 294 to 356 cm. In
> >> fact, I am
> >> > going to exchange all the quadrupoles of this input by
> replicas in
> >> > order to reduce a number of bodies in the file. It is my
> >> first step
> >> > in that direction. Is transformation correct? Why I do
> not see a
> >> > replica in the mentioned above position, if I plot
> >> geometry in FLAIR?
> >> >
> >> > In the attachment you can find my input file and two files
> >> which have
> >> > to be compiled for getting an executable file.
> >> >
> >> > Thank you for any assistance in advance.
> >> >
> >> > Best regards,
> >> > Vitaliy
> >> >
> >>
> >>
> >> Paola Sala
> >> INFN Milano
> >> tel. Milano +39-0250317374
> >> tel. CERN +41-227679148
> >>
> >>
> >
> >
>
>
> Paola Sala
> INFN Milano
> tel. Milano +39-0250317374
> tel. CERN +41-227679148
>
>