RE: [fluka-discuss]: Abort called from LATINP reason

From: Anton Lechner <>
Date: Sat, 30 Nov 2013 21:02:01 +0000

Dear Ghazaleh,

I just noticed that my previous answer was incomplete: multiple times you have a lattice of a lattice, which is not supported.

A solution could be to point from different empty lattice cells to the same real cell by using *different* transformations (instead of pointing from a lattice cell to another lattice cell). For this you then need different LATTICE and ROT-DEFI cards.

Apart from this:
* You have a geometry error in region Union3
* Due to numerical reasons, it is not recommended to have touching surfaces of RCCs (better to use an infinite cylinder and cut it with planes)

Cheers, Anton

From: [] on behalf of Anton Lechner []
Sent: 30 November 2013 20:39
Subject: RE: [fluka-discuss]: Abort called from LATINP reason

Dear Ghazaleh,

The issue can be solved by using lattice numbers instead of names for covering the multiple lattice definitions:
Replace the line
LATTICE L2 L81 LA2 LA81 rot#001
with following one:
LATTICE L2 L81 1. 80. rot#001

(apart from this, you seem to get geometry errors during stepping: please check your geometry)

Cheers, Anton

From: [] on behalf of []
Sent: 30 November 2013 18:57
Subject: [fluka-discuss]: Abort called from LATINP reason

Hello dear fluka users

I simulate a geometry but it doesn't run and I see below message

 Abort called from LATINP reason NR1+NRD!=NR2 FOR NAME INPUT Run stopped!

I don't know what should I do,I attach my geometry
please help me , It's very important

with best regard
Received on Sat Nov 30 2013 - 22:54:27 CET

This archive was generated by hypermail 2.3.0 : Sat Nov 30 2013 - 22:54:30 CET