How to vary some parameter automatically per run

From: Yung-Shun Yeh (adair.py94g@nctu.edu.tw)
Date: Fri Aug 17 2007 - 23:17:51 CEST

  • Next message: me@marychin.org: "icode=102 particle decay secondaries"

    Dear FLUKA users,

    I don't know if this question is appropriate in this forum.

    I am doing a simulation about estimation of muon-induced neutrons. In this
    simulation, I must vary the energy of primary muon and then do the
    simulation again. Earlier I varied the energy by hand, but it is not good
    method. Could anyone teach me any good way to deal with this routine. Thank
    you very much.

    Best regards,
    Yung-Shun

  • Next message: me@marychin.org: "icode=102 particle decay secondaries"

    This archive was generated by hypermail 2.1.6 : Sun Aug 19 2007 - 19:37:18 CEST