Re: FLUKA: Too big material number
>
> Remove the what(3)=8000. in BEAM and the error messages go away. What was
> that setting for??
>
Hi Stefan
It was used to make the directional distribution isotropic. Change it to 0.
which is
the default dose not make the errors in geometry, or in tracking disappear.
Please
see the discussion between Alberto and me.
Alberto thinks the solution may lie in modefing the tracking parameter using
undocumented methods. Can any one offer some advice on the HOWTO?
Regards
Fan
The information contained in this e-mail and any subsequent correspondence is
private and is intended solely for the intended recipient(s). For those other
than the intended recipient any disclosure, copying, distribution, or any
action taken or omitted to be taken in reliance on such information is
prohibited and may be unlawful.
Partial thread listing: