Hi Mike,
The message about the old flair expression is a warning. Take a look at this thread for more on this topic:
http://www.fluka.org/web_archive/earchive/new-fluka-discuss/11706.html
The reason why your input does not run is related to the FUDGEM parameter in the EMF-CUT with SDUM=PROD-CUT - the final message in the .err file:
*** Atomic electron contribution to mcs for material 3(HYDROGEN) set to 0, are you sure? ***
*** if so re-enter it as 1.E-05 and run again, if not check the manual for the ***
*** EMFCUT card, PROD-CUT, what(3), execution stopped meanwhile ***
This topic was briefly discussed here:
http://www.fluka.org/web_archive/earchive/new-fluka-discuss/11755.html
I hope this clears it up for you.
Best regards,
George
----- Original Message -----
From: "Michael Aiken" <aiken_at_jlab.org>
To: "FLUKA Discussion List" <fluka-discuss_at_fluka.org>
Sent: Tuesday, May 15, 2018 11:28:02 PM
Subject: [fluka-discuss]: Error with material assignment with new version.
I updated recently to the new version, and I'm having issues with one of my previously running simulation files (attached). The .err file shows a host of "old flair expression format no longer supported" messages as well as one detailing an incorrect material set. I can't seem to find what's hanging it up. I tried a number of other more simple simulations, and they are running perfectly fine. But this one and it's variants that I've created do not run any primaries.
__________________________________________________________________________
You can manage unsubscription from this mailing list at
https://www.fluka.org/fluka.php?id=acc_info
Received on Thu May 17 2018 - 20:32:01 CEST