Re: How to calculate dose?

(smtp1.mi.infn.it [192.84.138.69]); Wed, 13 Jun 2012 20:39:32 +0200 (CEST)
Sender: owner-fluka-discuss_at_mi.infn.it

Hi,

You might take a look at the manual :
- Generalised particles (to be used only for scoring): 240 = DOSE-EQ
section 5.1 note 6 especially)
- Description of card AUXSCORE
- Description of user routine fluscw.f if you need some other conversion
set, ie one of your own "kitchen" like I did sometimes.

Since a few versions deq99c.f routine (and the associated fluence to dose
conversion sets available) is included in fluka's code (version 2008.3 if
I'm right by one of our Authors could easily correct me if I'm wrong) if
you request (or activate it) by the use of 240.0 or DOSE-EQ generalised
particle in your detector (USRBIN, USRTRACK, USRBDX) and select the
adequate set and filter (to select the contribution of restricted type of
particle for instance) by means of AUXSCORE card.

Hope it helps.

Regards.
Sebastien.

> Hi I am continuing my education in FLUKA and first of all I want to
> express my acknowledgment to everyone who helped me.
>
> I came across to another problem. I read almost all articles about dose
> calculation but non of them helped me.
> I want to calculate dose outside of my concrete wall inside which beam
> with
> 20Mev energy hits the iron targed.
>
>
> How should I use user routine deq99c.f and where can I find it?
> Routine deq99c.f is not included under usrmvax directory in which user
> routines of fluka exist.
>
> Is dose calculation done with USERWEIG card with weight parameter set to
> FLUSCW?
>
> As I understand in order to use user routines I should compile deq99c.f
> routine in compile section and then use created executable in the
> Override options ( Exe ) of Flair Run section. After that all outputs of
> USRTRACK or USRBIN card will be automatically converted to dose plot.
> Am I right?
>
>
> Below I attached my input file. Thanks!
> I am using flair in virtualbox.
>
Received on Thu Jun 14 2012 - 00:32:10 CEST